1 . Do not wait until the battery is totally discharged .
Do not ever let your battery run out until the total dead or zero percent . Unlike the old battery nickel -based , if you do charge the li - ion or li - polymer to the total dead smartphones , it will worsen the quality and shorten battery life . Because , in the same time , the battery charge will take from 0-50 % greater power than the charge from 50-100 % .
2 . Use the proper charger .
Although you can use a smartphone charger from another brand , you should try to keep the default charger . This is to prevent the battery is filled beyond capacity and could cause the battery to explode . In addition , the current smartphone charger congenital usually clever , which already carry the current auto cut , which cut off the current to the battery when the battery is full .
3 . Never refill the battery fully .
Besides do not wait until the battery is totally discharged , as well as when you do charge . The best way of keeping the lithium- ion or lithium - polymer at long last up smartphone is unplug the charger before the battery is completely full and keep the battery in approximately 40-80 % figure . Although current smartphone battery was able to stop the charge when it is fully charged , you should avoid lingering conduct charge because it can make the battery becomes hot or bulging .
4 . Shut down during a charge .
The more cycles ( charge , use , charge , wear ) will further exacerbate the performance of the battery . For that , you should turn off devices when the battery is recharged , or at least when it is in sleep mode .
5 . Avoid hot spots . Therefore , one of the main enemies of li - ion and li - polymer is hot .
0 komentar :
Post a Comment